---

Click picture above for the plans.

---

Click here! Lost Foam

---

Here are some castings cut from the runners and cleaned up.
The bars are stock for the main bearings.

---

Here are some finished parts.

---

The base has 18 tapped holes. The mounting holes haven't been done yet.

---

Here is the standard ready for assembly.

---

Top end parts are finished. May 8, 2008

---

Here is the bottom end all put together. May 10, 2008

---

1/8" thick steel was soft soldered to a heavier piece of steel.
Be sure to have both pieces completely tinned! May 16, 2008

---

Then it was milled and drilled in the Haas. May 16, 2008

---

Machining the eccentric. Click Here!

---

Here are photos of the finished engine.

---

---

---

---

---

---

---

---

---

---

---

---

---

See it run on YouTube at: http://www.youtube.com/watch?v=5x82mEiH7_k

---